Sub Categories

Articles

IS 14817-3 (2004): Mechanical Vibration – Evaluation of Machine Vibration by Measurements on Non-Rotating Parts, part 3 Classification and evalutaion

Published On: 29-03-2021

  Machine classification Classification according to machine type, rated power or shaft height Rated Power (p KW) Shaft Height (h mm) Group 1 >300Kw >315mm …

IS 14817-3 (2004): Mechanical Vibration – Evaluation of Machine Vibration by Measurements on Non-Rotating Parts, part 2 Measurement procedures and operational conditions

Published On: 29-03-2021

  Measurement procedures and operational conditions Measurement Equipment Frequency range 10 Hz to 1000 Hz, ( ISO 2954, 10816-1) Speed <600 rpm frequency range <2Hz …

IS 14817-3 (2004): Mechanical Vibration – Evaluation of Machine Vibration by Measurements on Non-Rotating Parts, part 1 Scope

Published On: 29-03-2021

  Scope Inclusion steam turbines with power up to 50 MW; steam turbine sets with power greater than 50 MW and speeds below 1 500 …

IS 13583-1 (1993): Cranes – Training of drivers, Part 1: General _ practical program

Published On: 08-03-2021

  Practical programme Operating exercises Use of controls, operating aids and monitoring instruments  Executions of movements one by one, with no load. then loaded Combination …

IS 13583-1 (1993): Cranes – Training of drivers, Part 1: General_ Theoretical 2

Published On: 08-03-2021

  Theoretical programme part 2 Driving Driver’s cabin (access, safety and features contributing to the driver’s comfort)  Control and monitoring equipment Driving aids (indicators and …

IS 13583-1 (1993): Cranes – Training of drivers, Part 1: General_Theoretical 1

Published On: 08-03-2021

  Theoretical programme part 1 Driver: Aptitude and responsibility Role with handling team Technology of cranes Terminology and characteristics  Different versions and their methods of …

IS 12735 : 1994 Wire rope slings – safety criteria and inspection procedures for use Part 3 Annexure A & B

Published On: 18-02-2021

  Annexure A load stability Load will not swing if the Centre of gravity is below the main point of the sling Effect of out …

IS 12735 : 1994 Wire rope slings – safety criteria and inspection procedures for use Part 2 Inspection

Published On: 18-02-2021

  Inspection, thorough examination and discard criteria Inspection Check for  a) broken wires; b) distortion of the rope (crushing, kinking, etc.); c) distortion of ferrules, …