Articles

IS 12735 : 1994 Wire rope slings – safety criteria and inspection procedures for use Part 1 Use of wire ropes

Published On: 18-02-2021

  Use of wire rope slings Before lifting a load Load suitable for lifting wire rope sling and lugs and eye bolts should be used …

IS 11461 (1985): Code of practice for compressor safety Part 2 Potential hazards

Published On: 06-02-2021

  Potential hazard Improper Lubrication & cooling Cause Effect Improper lubricant Lack of oil Low oil pressure Over lubrication Temperature increase leads to fire Damage …

IS 11461 (1985): Code of practice for compressor safety Part 1 Definition and categories

Published On: 06-02-2021

  Definitions Maximum Allowable Working Pressure – The maximum operating air pressure which the manufacturer prescribes Relief Valve or Safety Valve Set Pressure -The pressure …

IS 11016 (1984): General safety requirements for machine tools and their operation part 3.1 additional requirement

Published On: 28-10-2020

  Additional Requirements part 1 Instructions for Servicing of Machine Tool at least two copies of detailed and legible descriptions of the machine tool, its …

IS 11016 (1984): General safety requirements for machine tools and their operation part 3.2 additional requirement

Published On: 28-10-2020

  Additional Requirements part 2 Working place operator is not disturbed by the neighbouring workplaces and that there is no obstruction to his movement during …

IS 11016 (1984): General safety requirements for machine tools and their operation part 4 duties and outfit of operator

Published On: 28-10-2020

  Duties of the Operator Duties of the Operator Before Starting the Work on the Machine Tools Check the oil level to make sure about …

IS 11016 (1984): General safety requirements for machine tools and their operation part 2.5 design requirements

Published On: 28-10-2020

  Design requirements part 5 Design of Electrical Equipment Regarding the safety requirements of electrical equipment for machine tools, standards have been formulated both at …

IS 11016 (1984): General safety requirements for machine tools and their operation part 2.4 design requirements

Published On: 28-10-2020

  Design requirements part 4 Designing for Protection Against Chips and Cutting Fluid design should provide for adjustable protective guards capable of arresting chips from …